| DMC106C |
TOOL KIT - TCAS CONNECTOR SERVICE, ROCKWELL COLLINS SYSTEM |
| DMC221MOD1 |
KIT - CRIMP TOOL, (ELECTRICAL/ELECTRONIC) REF FOUND IN STANDARD WIRE PRACTICES MANUAL (SWPM). |
| DMC921A |
KIT - CRIMP TOOL, RF & ELECTRICAL CONNECTORS (ADD ON KIT TO DMC201MOD1, AND CONTAINS TOOL FROM DMC921 NOT FOUND IN DMC201MOD1) REF FOUND IN STANDARD WIRE PRACTICES MANUAL (SWPM). |
| F0808MT1-A01-003.3 REV A |
Cable - Fiber Optic, SC Connector |
| F0812MT1-A01-003.3 REV A |
Cable - Fiber Optic, SC-LC Connector |
| F-28SM-01 |
Adapter - Fiber Optic, SC |
| F65-0-3311 |
Adapter - Test, Nose Wheel Steering Metering Valve |
| FBP-ARINC-01 |
INSPECTION KIT - FIBER OPTIC |
| FBPT-C130 |
INTERFACE TIP - FIBER OPTIC, INSPECTION |
| FBPT-LC |
BULKHEAD TIP - FIBER OPTIC, INSPECTION, LC-TYPE |
| FBPT-LUX24-G001 |
GUIDE - INSPECTION, 24 TERMINI, PLUG/SOCKETS, FIBER OPTIC |
| FBPT-LUX24-G002 |
GUIDE - INSPECTION, 24 TERMINI, RECEPTACLE/PINS, FIBER OPTIC |
| FBPT-SC |
PATCH CORD TIP - FIBER OPTIC, INSPECTION, SC-TYPE |
| FBPT-U25M |
PATCH CORD TIP - FIBER OPTIC, INSPECTION |
| FCL-ARINC-01 |
INSPECTION KIT - FIBER OPTIC (WITH CLEANBLAST) |
| FDS400-202 |
Cable - Adapter, HHMPI (L-3 Comm FA2100 DFDR only) |
| FDS400-203 |
CABLE - ADAPTER, HHMPI (FOR HONEYWELL SSFDR) |
| G01M1 |
KIT - CRIMP TOOL, ELECTRICAL POWER CONNECTORS REF FOUND IN STANDARD WIRE PRACTICES MANUAL (SWPM). |
| G01M3 |
KIT, CRIMP TOOL - POWER & RF ELECTRICAL CONNECTORS (CONSISTS OF P/N G01M1 & G01M2) REF FOUND IN STANDARD WIRE PRACTICES MANUAL (SWPM). |
| G01M9 |
KIT - CRIMP TOOL, (ELECTRICAL/ELECTRONIC) (GENERAL PURPOSE REPAIR AT LINE STATIONS) REF FOUND IN STANDARD WIRE PRACTICES MANUAL (SWPM). |
| G20008 |
Personnel Equipment - Shock Absorbing Lanyard, Engine / Strut ** Safety ** |
| G21013-1 |
Heater Test Cable |
| G27086-1 |
Measuring Eqpt - Freeplay, Lower Rudder Tab |
| G27104 |
Actuator/Deactuator BOB - Thrust Reverser Proximity Sensors |
| G28005-48 |
Check Fixture Equipment - Pressure Relief Valve |
| G28018-26 |
Equipment - Test, Engine Fuel Feed Manifold |
| G28018-33 |
Fitting - CF6-80C2, GEnx-2B, PW4000, and POW4084 Engine Fuel Feed Manifold |
| G28020-1 |
Wrench - Shroud, APU Fuel Drain |
| G28021-TBD |
Gage Assembly - Pressure Test, Fuel Tank Manifold |
| G29014-1 |
Return Extension Adapter - Ground Service Disconnect, L/R Hydraulic Systems (Assembly G29014-2 is included in kit G29014-1) |
| G32014-28 |
TESTER - SENSOR, BRAKE CONTROL TORQUE |
| G32028-146 |
Jack - Wing / Body, Main Landing Gear |
| G32059-1 |
Locating Jig - Air Gap Rigging Tool, Wing Landing Gear |
| G36045-1 |
Duct Plugs - Bleed Air System Pressure and Leak Test |
| G36047-1 |
Blanking Plate - Leak Test, Pressure Compensator Duct |
| G36050-TBD |
ADAPTER ASSY - OPV, FUNCTIONAL TEST |
| G38008-1 |
Temporary Floor Covering |
| G46001-1 |
Breakout Equipment - Onboard Network System (ONS) |
| G52003-25 |
Strut - Safety, Side Cargo Door |
| G52035-1 |
Spanner Wrench Equipment |
| G53001-103 |
SCAFFOLD - ACCESS, PRESSURE BULKHEAD (DOES NOT INCLUDE -98 LADDER) |
| G78010-1 |
Stand - Transportation/Work, Thrust Reverser |
| G87D |
Gun - Lockbolt, 13/16 Inch Stroke and Minimum of 6500 Lb Pulling Capacity |
| GPS-101 |
TEST SET - GLOBAL POSITIONING SATELLITE (GPS) |
| HT2000-1-E/1-S |
CART HYDRAULIC TEST (3000 PSI, 50 GPM, 60 GALLON SUPPLY) |
| HT2000-2-E/1-S-X350 |
CART HYDRAULIC TEST (5000 PSI, 55 GPM, FLOWMETER ACCURACY 0.3% OF MEASURED VALUE, 160 DEGREE F FLUID OVERTEMP AUTOMATIC SHUTDOWN) |
| HT210-16 |
TESTER - CONTACT RETENTION GAUGE 16 |
| HT210-20 |
TESTER - CONTACT RETENTION GAUGE 20 |
| J46002-9 |
Breakout Box - ARINC-600 Connector, Fiber Optic |
| J71039-155 |
Guard - Inlet, Engine Runup Safety |
| LJ015U1310-5 |
Locating Jig - Air Gap Rigging Tool, Wing Landing Gear |
| M15570-20 |
Tool - Wire Insertion and Extraction |
| MHP-1 |
HYDRAULIC PUMP - MANUAL, HAND |
| MICROBMONITOR2 |
Test Kit - Microbial, Fuel EASICULT COMBI |
| MODEL 281 |
GENERATOR - SIGNAL |
| MODEL 43 |
METER - RF POWER, THRULINE R.F. WATTMETER. MUST REQUEST CALIBRATION CERTIFICATE TO NIST. |
| MODEL 5900 |
Supply - Power provides, max output 70 VA / continuous 50 VA, 45 hz - 20 Khz |
| NAV-2000R-70 |
GENERATOR - NAV/COMM, SIGNAL (ADF, MARKER BEACON, VOR, LOC, GLIDESLOPE, HF, VHF, SELCAL AND UHF COMM RECEIVERS) |
| PPFC-1H |
HEAD/CYLINDER ASSEMBLY - AMP COPALUM (FROM 8,500 PSI TO 9,000 PSI / AWG 8 - 00) |
| RTSK8-02-006 |
Swager - Hydraulic Fitting |
